Koffee_Kosmo Good luck with the new acquisition If I need a small job it's closer to you than AM :stir
Koffee_Kosmo derrilex wrote: I'm so out of my depth at the moment 😃 I did some fitting and turning when at the BHP
derrilex Your bits are done Brett, for better or worse 😃 . If you could measure the diameter of the hole for me ( with verniers) that would be great.
Brett_H derrilex wrote: Your bits are done Brett, for better or worse 😃 . If you could measure the diameter of the hole for me ( with verniers) that would be great. 31.5 inside the tap/hole. 31.64 tapering to 31.24 at 8mm depth. :head:
texx you should be able to make lots of big bits of wood smaller with that one . but i have never been a fan of the swivel head lathes , i have 2 lathes and my next one will be a w387 style lathe ( sliding head stock ) i know a few guys that have them and swear by them . ( much heavier stand on them too ) like the hare and forbes WL46a. johno
derrilex I'm lovin' it texx. I dont know enough ( or anything) to really compare it to any others. I'm just feeling my way at the moment. Luckily, resin is soft so know major fuck ups, yet. A few moments but all recoverable. :thumb:
